Jim Mac's Figuera Thread

[Jim Mac]

I am going to document what I see with this new setup idea - What I see will be shared as steps continue.

As I laid out in the Honda thread, I am trying the Figuera setup with one of the primaries being used as a "Drag" coil instead of being actively powered..

Here you can see the basic "Drag Coil" conditions in slow movement..  



I am simply measuring resistance in a closed unpowered circuit..  The "Drag Coil" will be cut in here and simply act as a Varying Resistance Load"  that is in-sync with the drive coil's phase.  

The purpose is to make the output coil respond like a Dynamo by introducing "Drag".  So basically, the output coil will take on 2 roles..  It is induced by the primary powered coil when the primary magnetic field is GROWING-  BUT the output coil also takes on the role of a primary when the drive coil's magnetic field is Shrinking..  

See, when the drive coil's field shrinks, the resistance in the "Drag Coil" DROPS in relation.  This should cause Opposition to the output coil on the pulling away or shrinking field-  that will hopefully kick the system into High-Gear while drastically lowering the input requirement.

[Jim Mac]

Here is a video watching the closed resistance on Both Sides at once..  As you know,  one side raises resistance as the other Lowers like a Teeter Totter.



Now to get to coil testing..  There are all sorts of configurations to try..  For instance do the roles need to keep switching?  For instance, Coil A grows and shrinks while coil B is the acting Drag Coil.  But then Coil B Grows and Shrinks while Coil A becomes the Drag Coil..  Or is 1 dedicated Drag Coil enough with no switching?

OR does Coil A Grow North, Shrink North, then FLIP and Grow South then Shrink South while the other is ALWAYS the Drag Coil?

There are numerous possibilities that should be tried..   

Just want to point out,  I see NOTHING in any of Figuera or Buforn's patents that specifically say "the coil negatives Both Tie Together And Go To Ground".  Infact, something suspicious is happening on those ground connections as been pointed out many times, and even Lasco and Escumo are experimenting with..  


Hopefully something will occur

[Jim Mac]

EDIT with correct info..

As an update.  I been trying different configurations On and Off today.  I see about 1/3 of the input current flowing through the the drag coils on either side, So totaling about 2/3.  But no improvement in output power from this yet.

Next I will add the ability to switch polarity to further try all configurations with the "Drag Coil"  including Lasco's reported method.  Withj my electronic version, I have 24 steps and can operate high speed with no sparking.  So we will see