09-20-2023, 09:23 PM
(09-20-2023, 08:26 PM)Dr.Wlazlak Wrote: This look interesting:
When do you think it will be done?
tom
Not sure- but I am printing now.. This is the rotor design I came up with.. The bearing holders are embedded in the ends.
This is a more complicated print for me, so I am not sure the outcome yet. I will know more by morning when it's done printing.
The magnets fit exactly inside a 2" PVC pipe to the wall. So I can align them perfectly with the pipe. Then if it works, I can use the pipe as a resin mold to encase it.
This idea can be done in other ways for sure.. I was alerted to a video of the same concept https://www.youtube.com/watch?v=HK3JOlY0V8Y&t=1059s