The key to this subject is something that run using no energy to run on

[Dr.Wlazlak]

Thanks for sharing Jim
Hi Tom in the drawing are the two disks covered with wire?
Also is the coil wound on the iron core and sandwiched between the disks?
Last but not least is the magnet stationary since the bolt that goes through it threads into the rotor?
Thanks

There is a photo of the EttCM coil on the Electiric Motor string 
The magnetic goes on the end of the coil and is fixed to the iron core as one complete part
This means that the iron core is now under a permanent magnetic force made be the magnetic on it.
if watts power is On and the direction of the coil poles are such N/S of the coil and N/S of the magnet
The output of the coil could be 5 times that of a normal coil at the same watts input
This makes this possible to build a device that produces more output watts than is input to make it run.
But the key to this is turning OFF the permanent magnetic force so the back Emf goes to Zero
This will be explained many times in many places as I tell how this technology Works
Thanks you, Tom aka. Dr. Wlazlak