Join us in the search for Free Energy. Share your experiments and discoveries, post your build logs, and discuss.
We have a strict No-Troll policy. So you can post without fear of being ridiculed.

New Members- Check Your Spam Folder For Activation Link

Please read our Rules. Any problems or suggestions- Contact Us


Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Mooker's No Lenz Magnet Generator
#14
(09-20-2023, 04:28 PM)Dr.Wlazlak Wrote: Hi Jim
I noticed something about the turning of the screw.
if you had a wheel that had magnets all around the outside of the wheel same pole
and rolled the wheel across a flat type iron core coil - like a wheel from on end to the other end of the coil back and forth
This is much the same as the screw rotor does
there would be little Lenz effect because the front side of the wheel is pushing as it rolls and the backside of the wheel is pulling as much out as the front is pushing in.
The screw is doing this much in the same way as the wheel does.

can you see that also?

Tom

Unfortunately, the induction is backwards in that model you describe. The coil will slow you at every point.

The coil has 2 polarities you pass. And the wheel only has 1.  If the wheel was South, the coil would react like the image below.

   

The system should cause magnetic movement perpendicular to the physical motion to beat lenz. And there can not be gears or any other mechanical transfer of energy.  

So even if your coil was straight up and the wheel rolled over the top- it would still oppose the motion on both sides..
Reply


Messages In This Thread
Mooker's No Lenz Magnet Generator - by Jim Mac - 09-12-2023, 11:56 AM
RE: Mooker's No Lenz Magnet Generator - by Shylo - 09-15-2023, 02:46 AM
RE: Mooker's No Lenz Magnet Generator - by Escumo - 09-15-2023, 04:02 AM
RE: Mooker's No Lenz Magnet Generator - by Dr.Wlazlak - 09-19-2023, 07:48 PM
RE: Mooker's No Lenz Magnet Generator - by Shylo - 09-20-2023, 03:43 AM
RE: Mooker's No Lenz Magnet Generator - by Dr.Wlazlak - 09-20-2023, 04:06 AM
RE: Mooker's No Lenz Magnet Generator - by Dr.Wlazlak - 09-20-2023, 04:28 PM
RE: Mooker's No Lenz Magnet Generator - by Jim Mac - 09-20-2023, 05:09 PM
RE: Mooker's No Lenz Magnet Generator - by Dr.Wlazlak - 09-20-2023, 05:32 PM
RE: Mooker's No Lenz Magnet Generator - by Dr.Wlazlak - 09-20-2023, 08:26 PM
RE: Mooker's No Lenz Magnet Generator - by Dr.Wlazlak - 09-21-2023, 02:52 AM
RE: Mooker's No Lenz Magnet Generator - by Shylo - 09-23-2023, 05:32 AM
RE: Mooker's No Lenz Magnet Generator - by Shylo - 10-01-2023, 05:48 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)